Print this Product

Pure Water Filter System

As you will see from the detail information below, this is one of the most comprehensive filter systems available. We are very exited to be able to support people with Pure Mineral Water flowing through there whole home. The system comes with the Patented ER Alloy® media, which lasts a full 2 years before it needs replacing.

All BPA free, NSF and FDA approved system.

Five Key Reasons To Buy A Water Treatment System:

  • Filtering
  • Softening
  • Ionising
  • Alkalising

The Pure Water Filter System provides all these functions in one system that is eco-friendly and cost effective.

Advanced Multi-stage Mineral Water Purification and Activation system

In stage 1, Water flows through one - micron filter pads (1 micron equals 1/25,000th of an inch), which remove suspended particles such as silt, sediment, cyst (Giardia, Cryptosporidium), sand, rust, dirt, and other un-dissolved matter.

In stage 2, (Activated Carbon Filter) Water flows through coconut shell granulated activated carbon (GAC). GAC is universally recognized and widely used as an effective adsorbent for a wide variety of organic contaminants, such as chlorine (99.9%), chemicals linked to cancer (THM's, benzene) pesticides, herbicides, insecticides, volatile organic compounds (VOC's),  PCB's, MTBE's and hundreds of other chemical contaminants that may be present in water that create bad taste and odours.

Carbon is extremely porous and provides a large surface area for contaminants to collect. Carbon-only filters must also use their capacity for chlorine removal, resulting in a shortened life. They also may use a bituminous coal carbon, which is good at removing chlorine, but not as effective at removing chemicals. We use a high-grade coconut shell carbon that is most effective at removing chemicals. Coconut shell carbon provides a significantly higher volume of micropores than either coal-, wood or lignite-based carbon. As a result, it is more effective than other carbon types in removing trihalomethanes (THM's) and other chemicals from municipally supplied water. Since our REDOX media removes the chlorine before it reaches the carbon, the carbon capacity is not wasted on chlorine and is free to concentrate more effectively on organic contaminants.

In stage 3, Water flows through the ion exchange resin, reducing heavy metals such as lead, copper, aluminium, and water hardness. (Natural Water Softener)

In stages 4 and 5, Water flows through a bed of media made of a special high-purity alloy blend of two dissimilar metals - copper and zinc.

ER Alloy® is a major advancement in water treatment technology that works on the electro-chemical and spontaneous-oxidation-reduction (REDOX) principles. Chlorine is instantaneously and almost inexhaustibly oxidized.

Tests on the Alloy/GAC cartridge have shown 99+% chlorine removal past 20,000 gallons of water. (In comparison, carbon cartridges of comparable volumes drop below 90% effectiveness after only 4,000 gallons.)

Iron and hydrogen sulphide are oxidized into insoluble matter and attach to the surface of the media. Heavy metals such as lead, mercury, copper, nickel, chromium, cadmium, aluminium, and other dissolved metals are removed from the water by the electrochemical process. They are attracted to the surface of the media, much like a magnet. The media inhibits bacterial growth throughout the entire unit in fact, it has been shown to be reduced up to 90%, eliminating the need for silver, which is commonly used in carbon-only filters (silver is considered a pesticide by the EPA and, as such, must be registered with them).

Is copper or zinc added to the water in any significant amount? On 2.3ppm chlorinated water, <0.05mg/l copper and only 0.46mg/l zinc were measured. The EPA aesthetic levels are 1.0 mg/l for copper and 5.0mg/l for zinc. Both zinc and copper are essential minerals for good health - the FDA recommends a daily intake of 15 mg of zinc and 2 mg of copper.

In stage 6, Water flows through another one-micron filtration pad for further reduction of undesirable particles. The end result is a great reduction or the total elimination  of a wide variety of contaminants. ER Alloy® is a patented product and a major advancement in water treatment technology that works on the basic process known as REDOX (oxidation/reduction) principles, representing a new and unique way of water processing medium which by its natural process of electrochemical oxidation/reduction and adsorption action reduces and/or removes many unwanted contaminants from water.

ER Alloy® medium is a versatile, specially formulated high purity, bimetal material. This product operates as a multifunctional medium, which has superior capabilities of de-chlorination of drinking water and reduces dissolved heavy metals in water supplies. ER alloys are Antimicrobials. (An antimicrobial is a substance that kills or inhibits the growth of microorganisms such as bacteria, fungi, algae and mould or protozoans). ER65 and 95 alloys antimicrobial properties never deteriorate or deplete.

Patented ER Alloy® media consists of a high purity copper-zinc formulation. These substances exchange electrons or bond with chlorine and other metals contained in the water to create harmless substances. ER Alloy® is completely safe and meets EPA and FDA standards for levels of zinc and copper in potable water, so the process is not toxic and does not cause any adverse side effects.

Quantity

Price: £397.00

Loading Updating cart...
LoadingUpdating...

Permanent link to this article: http://mineralwaterfilter.co.uk/products-page/water-filter-systems/pure-water-filter-system/

Leave a Reply

Your email address will not be published. Required fields are marked *